Servicing HP Mid-Range Integrity Servers
Questions, Answers, Braindumps (HP0-382)
These are Guaranteed Questions for HP0-382 exam. I
only used www.exams.ws guide and i was through.
Which command displays a list of devices and their
system paths on an rx7620 server running HP-UX?
A. show device
D. list devicesD.list devices
The following HP-UX hardware path is form an rx8620
system with an attached Server Expansion Unit (SEU)?
Where is the device associated with this path located?
A. Where is the device associated with this
B. PCI-x slot in the SEU
C. Core I/O in the rx8620 enclosure
D. PCI-X slot in the rx8620 enclosure
Which SDA command shows a list of PCI devices and
the associated hardware path values on an rx7620 server
A. CLUE CONFIG
B. SHOW DEVICE /PCI
C. CLUE SYSTEM
D. SHOW RESOURCES
On an HP Integrity server running Linux, you execute
the Ispci command and receive the following:
40:01.0 Fibre Channel: QLogic Corp. QLA2312 Fibre
Channel Adapter (rev 03)
40:01.1 Fibre Channel: QLogic Corp. QLA2312 Fibre
Channel Adapter (rev 03)
How do you interpret this? Select 2.
A. There are two seperate Fibre Channel PcI
B. There is one Fibre Channel PCI card installed with
C. the card(s) are installed in a PCI-slot connected
to rope 2.
D. The card(s) are installed in a PCI-slot connected
to rope 4.
What is the OpenVMS command to get an I/O device list
on HP Integrity server?
C. scan device
D. show deviceD.show device
On an HP Integrity rx8620 server, which statement
is correct for "cell-local memory" (CLM)?
A. You should always use 100% CLM when doing
a Windows installation.
B. You can change from CLM to "Interleaved memory
" by changing kernel parameters.
C. CLM is a feature of the HP-UX Virtual Partitions
software and can be created with "vparcreate-CLM:100:0:0........"
D. To set up CLM,you have to install at least two
echelons (four DIMMs) in special slots on the cell
board (slot CLM0A-CLM0C and CLM0D).
Which statements are true regarding memory configurations
for the rx7620 server?Select 2.
A. A minimum of two DIMMs are required per
B. A minimum of four DIMMs are required per cell.
C. DIMM additions must be in sets of four per cell.
D. For a 4-cell system, the maximum quantity of DIMMs
What is "MX2"?
A. a one-socket,daul processor module for
B. the public code name of the next generation Itanium
3 CPUs from Intel
C. an HP PCI-e RAID controller with Fibre Channel
Connections and support for Up to 2 TB
D. a part of the memory subystem of the HP sx1000
chipset that acts as a memory multiplexer to increae
the memory bandwidth
What are key features of the rx7620 and rx8620 memory
subsystems? Select 2.
A. chip spare chip kill
B. parity protection on the data lines
C. parity protection on the address and control lines
D. DIMMs can be transfered from rp5400 system
E. address ECC correction is generated on the DIMMs.