Servicing HP Large Format Printers & MFP
Questions, Answers, Braindumps (HP0-262)
1st of all I thank to all the dumpers who all sent
their braindumps to this site and helped others. Secondly
thanx to www.exams.ws
QNO: 1 What is not a step in removing
the carriage assembly?
A. Disconnect the trailing cable from the connector
on the carriage
B. Remove the encoder strip
C. Press the carriage motor towards the left, and
remove the belt from the motor shaft
D. Slide the carriage to the left, and remove it with
the belt from the printer.
QNO: 2 Which side (or sides) of the
belt has teeth in its surface on the 7XX series Large
A. the inner side of the belt to provide the retention
on the scan axis motor
B. the outer side of the belt to engage the carriage
C. there are no teeth at all
D. there are teeth on both sides
QNO: 3 On the DesignJet 1000 series
printers, in which front panel menu would you find
information on printer firmware?
A. I/O setup
C. Page setup
D. Device setup
QNO: 4 On the DesignJet copier and
scanner series, what special error reporting exists?
A. Windows messages on the front panel touch screen
B. Service Print and LED codes on the scanner front
C. System Error (SE) on the front panel of the output
printer, error messages on the front panel touch screen
D. error messages on the WIDEsystem, error messages
on the front panel touch screen, and LED codes on
the scanner front panel
QNO: 5 What does a flashing Ready
LED indicate on the 4XX series Large Format printer?
A. The setup key needs to be pressed.
B. The printer is ready for a plot to be sent.
C. The printer is busy with a task or receiving a
D. The cover needs to be closed.
QNO: 6 On a DesignJet 1000 series
printer, configuration information is held in the
EEROM within the electronics module and in which other
field replaceable unit?
A. Ink Supply Station (ISS)
B. tubes assembly
D. service station
QNO: 7 When you replace a print head
on a DesignJet 1000 series printer, which other component
must be replaced?
A. ink cartridge
B. print head sensor
C. tubing assembly
D. print head cleaner
QNO: 8 What is indicated when the
ink cartridge status displays as 'unknown' on a DesignJet
1000 series printer?
A. The ink level is unknown.
B. The ink cartridge is not approved.
C. The ink cartridge has a continuity problem.
D. The ink cartridge is empty.
QNO: 9 How is the bail lift mechanism
actuated on the 7XX series Large Format Printer?
A. by the carriage engaging the bail lift lever
B. through the bail stepper motor
C. manually through the front panel
D. there is no bail mechanism