Nortel Secure Router Rls.2.0 Configuration & Management
Exam Questions, Answers,
Thanks to www.exams.ws and www.examcheets.com .
Where do you specify the cable type on a 3120 serial
A. Under the bundle configuration
B. Under the module configuration
C. The cable type is automatically configured
D. The modules come pre-set for a specific cable type
As an engineer, you are enabling OSPF on the Nortel
Secure Router. You have already configured and tested
your Ethernet ports and WAN links. Which is the next
A. Do nothing, OSPF is enabled by default.
B. Configure OSPF on the associated interfaces.
C. Type router ospf from the configure prompt.
D. Create a router ID using a configured IP address
on the router.
Which is the correct syntax to view only OSPF routes?
A. show ip route
B. show route ospf
C. show ip route ospf
D. show ip ospf route
To view all of your OSPF neighbor(s), and verify their
IP address, router id and state of the connection,
which command can you use?
A. show ip ospf neighbor detail
B. show ip route ospf neighbor detail
C. show ip ospf database database_summary
D. You cannot view all that information in one command.
When you first log into the HTTP GUI, which screen
will you see?
A. System Summary
B. System Configuration
C. Guided System Setup
D. System Administration
Which of the Nortel Secure Router interfaces will
accept requests for the HTTP GUI?
A. Any Interface
B. Loopback address
C. Any WAN Interface
D. Any Ethernet interface
Which tabs of the HTTP GUI shows you categories in
which you can configure the basic router settings?
C. Guided Setup
For remote VPN access user groups, which is required?
A. AAA authentication for each user group
B. an IKE and IPSec policy for each user group
C. nothing is required, no support for user groups
D. an IKE template that will be attached to the group