|
Braindumps
of 920-215
Passport 7000/15000
Exam Questions,
Answers, Braindumps (920-215)
Hi Frds!.
I did not know any exams stuff site. I got the names
of some sites form here like www.exams.ws . I followed
the suggestions and yes thanks to the right guidance
that I got through. Here are some of my questions
as braindumps.
QUESTION 1:
When performing card tests which two conditions are
true? (choose two)
A. A card can be the target of multiple card tests.
B. Both the card being tested and the target card
must be locked.
C. The card being tested can only have one card set
as its target.
D. Both the card being tested and the target card
must be the same type.
Answer: A,C
QUESTION 2:
Which test will best help to detect intermittent fabric
card faults?
A. ping test
B. broadcast test
C. clock source test
D. bus tap test self-test
Answer: A
QUESTION 3:
When running manual test between two Passport 7000
/ 15000S connected be a DS 3 port, one Passport has
its DS3 test component's type set to manual? What
is the correct value for attribute type? On the test
component of the remote Passport?
A. card
B. localloop
C. remoteloop
D. externalloop
Answer: D
QUESTION 4:
Which condition is true when performing a card test?
A. The card being tested needs to be locked
B. The ports on the card being tested need to be locked
C. The target card's test component needs to be started
first
D. A card can be both running a test and act as a
target for another card being tested
Answer: D
QUESTION 5:
When diagnostic port testes require a physical connection
to another Passport for the test to run properly?
A. card
B. active loop
C. payload loop
D. external loop
Answer: C,D
QUESTION 6:
Which piece of hardware on a Passport 15000 contains
temperature sensors?
A. Shelf
B. BITS/Alarm module
C. MAC address module
D. Breaker interface panel
Answer: A
QUESTION 7:
Which card on a Passport 7400 does not require a termination
panel?
A. E1
B. DS1
C. OC3
D. DS3c
Answer: D
920-215
|
