Meridian SL-100 Maintenance
Questions, Answers, Braindumps (920-110)
is my contribution for this great site and its braindumps
What must you do when you return a card to Nortel
Networks for repair or replacement?
A. Pack the card security in the original carton.
B. Mark the carton with your name and return address.
C. Wrap the card in Anti-ESD packing material and
bubble wrap or foam.
D. Call Nortel Networks after you ship the card to
give them the shipper;s tracking number.
The fan-fail indicator on the front of the MCRM-S
is illuminated. What shold you do? (Choose two)
A. Follow procedure for replacing the faulty fan unit
B. Follow procedure for identifying the faulty fan
C. Follow procedure for manually busying the fan unit
D. Follow procedure for inspecting and changing bulbs
on the faulty fan.
The disk-drive unit (DDU) is generating excessive
errors on a particular volume. From the DDU level
of the IOC, the volume status is open?and read-only?and
the system cannot process the space file. After following
the correct procedures, you access the disk-allocation
(DSKALLOC) utility for that specific DDU from the
C1 level. What command sequence should you use to
regain access to this volume?
A. display,reinit vol_name; update; display,quit
B. display,reinit vol_name; add vol_name num_blks;update,quit
C. display,delete vol_name;diradd vol_name;update;display;quit
D. display,delete vol_name;add vol_name num_blks;diradd
Which is true of Remote Line Concentrating Module
(LCM) routline exercise tests (REX)?
A. No more than two can run at the same time
B. LCM REX testing is controlled by the CPU in LCM0
C. LCMCOV REX verifies the power converter and the
D. If the RLCM is equipped with emergency stand-alone
(ESA) capability, the RLCM performs a REX and ESA
While completing a battery check, you find blue post
corrosion. What are some corrective steps? (Choose
A. Clean the post thoroughly
B. Re-install the affected connector.
C. Wash the post with mild detergent
D. Replace the affected intercell connector.
You are troubleshooting a faulty DS0 with the distant-end
toll-office switch-maintenance engineer. The number
for your office test-line that will provide a far-to-near
transmission loss and noise measurements is requested.
Choose the appropriate test line.
Identify steps you should complete during a power
plant check. (Choose two)
A. Check the air conditioning in the plant room.
B. Make sure the fuse alarms are functioning properly
C. Rotate the in-service fuses with those in the spares
D. Check that the power-plant voltage is within the