REAL QUESTIONS SUBMIT MATERIAL ADVERTISE
Braindumps

Microsoft

Cisco

Citrix

CIW

CompTia

CWNA

Apple

Adobe

HP

Legato

Exin

Filemaker

Brocade

Ericsson

TIA

Veritas

ISEB

SCP

IISFA

ISM

OMG

Apc

Mile2

Foundry

Huawei

McData

Symantec

TeraData

RedHat

Solar Winds

Blue Coat

Riverbed

 

 
 
Click on name of dumper to view the dump
 
Amelia
 
 

 

Braindumps of NS0-131
Network Appliance Data Protection Exam 7G

Exam Questions, Answers, Braindumps (NS0-131)

I had enjoyed the paper after getting help from the dumps of www.braindumps.org. Here is my contribution.

Q: 1
You work as a network administrator at Company.com. You want to create an automated test environment that performs a single file SnapRestore. Every time you run the procedure, however, SnapRestore prompts you to confirm your decision to revert the file. How can you automate this step?
A. Enter the priv set advanced mode on the storage appliance and the prompt will not appear.
B. Enable the options snaprestore_noprompts enable=on option.
C. Use the option with the snap restore command.
D. These prompts are for data protection and auditing and cannot be overridden.
Answer: C

Q: 2
Which one of the following actions will cause a currently in sync snapmirror relationship to fall out of sync?
A. Modifying the /etc/snapmirror.conf file on the source storage appliance
B. Modifying the /etc/snapmirror.conf file on the destination storage appliance
C. Running snapmirror update on the source storage appliance
D. Running snapmirror release on the source storage appliance
Answer: B

Q: 3
SnapMirror qtree replication can be set up for a maximum of ____ qtrees on any one volume.
A. 1995
B. 2995
C. 3995
D. 4995
Answer: D

Q: 4
One week ago you performed a single file SnapRestore from a snapshot other than the most recent. You now notice that the storage appliance is now taking longer to perform snapshot deletions. Which of the following reasons is the most likely cause of this problem?
A. Snapshots that existed after the one used for the single file SnapRestore need to be manually deleted.
B. The SnapRestore schedule changed from weekly to hourly.
C. All of the snapshots created after you did the single file SnapRestore were deleted, and reserved inodes from the snapshots still exist.
D. Before a snapshot can be deleted, the active maps across all snapshots need to be checked for active blocks related to the file you restored.
Answer: D

Q: 5
When you are setting up SnapMirror, which one of the following is not a replication pre-requisite?
A. SnapMirror must be licensed for each storage appliance.
B. The source volume must be offline.
C. If you are replicating a volume, you must create a restricted volume to be used as the SnapMirror destination volume.
D. The capacity of the SnapMirror destination must be greater than or equal to the capacity of the source.
Answer: B

Q: 6
How can you throttle SnapVault updates and baseline transfers so that the primary or secondary is not transmitting data as fast as it can?
A. Use the -k option in the snapvault start command.
B. Use the snapvault throttle command.
C. SnapVault doesn support throttling of network throughput.
D. None of the above
Answer: A

Q: 7
Which two of the following NetApp storage appliances do not support the use of synchronous SnapMirror?
A. F825
B. FAS960
C. F87
D. F820
Answer: C, D

Q: 8
Five minutes ago, you performed a single file SnapRestore on a large NFS file. 40% of your NFS users are now complaining about getting tale file handles?for the file. Which one of the following is the most likely cause of this problem, and the best procedure to correct it?
A. These users are on a different subnet from the others. Start troubleshooting by checking their subnet.
B. After a single file SnapRestore, NFS users have to reboot their systems. Have them reboot their systems.
C. This might be due to an NFS storage appliance and client version mis-match. Check to see that these users have the same version of the NFS client that existed at the time the snapshot was taken.
D. NFS users who try to access a reverted file without first reopening it might get a tale file handle error message. Have the users try to reopen the file and see if the problem is resolved.
Answer: D

NS0-131


 

 

Braindumps Real exam questions and verified answers - 100% passing guarantee - cheap prices.

 

Free brain dumps Braindumps, notes, books for free

 

Braindumps and Exams - Instant download real exam questions - Passing guarantee.

Follow us on FaceBook
Braindumps on Facebook
 
 
 
 
 

CheckPoint

Linux

Novell

DB/2

Network Appliance

EC-Council

Nortel

McAfee

Juniper

ISACA

PMI

Sybase

EMC

HDI

SNIA

ISC

Sair

IBM

Lotus

Exam Express

3COM

BICSI

DeLL

Enterasys

Extreme Networks

Guidance Software

Computer Associates

Network General

SAS Institute

Alcatel Lucent

SeeBeyond

TruSecure

Polycom

Hyperion

Hitachi

Nokia

Fortinet

Vmware

Fujitsu

Tibco

Intel

PostgreSQLCE

BusinessObjects

RESSoftware

BlackBerry

AccessData

ICDL

Isilon

SAP

The Open Group

ACSM

Altiris

Avaya

Cognos

F5

Genesys

SDI

ACI

ASQ

Google

H3C

HIPAA

HRCI

SOA

IIBA

Zend