System I Operations V5.07.10
Answers, Braindumps (000-970)
Thanx to www.exams.ws for providing helpful material
An operator wants to check the status of a LAN adapter
called Lin01 on Mysystem using System I Navigator.
After expanding My Connections -> Mysystem ->
Configuration and Service. Which of the following
tasks will accomplish this?
A. Expand Network -> Hardware -> Adapters.
Right-click Lin01 and select properties
B. Expand Hardware -> Communications. The status
is displayed to the right of Lin01
C. Expand Hardware -> LAN Resources -> Adapters.
The status is displayed to the right of Lin01
D. Expand Network -> Hardware -> Communications
-> Adapters. Right-click Lin01 and select properties
Which of the following is required for a full system
A. All file systems must be mounted.
B. The system must be in restricted state.
C. All communications line descriptions must be varied
D. The user performing the save must have *ALLOBJ
The operator has been asked to back up 3 libraries
to disk. Which of the following would the operator
perform to accomplish this?
A. Create one save file. Perform a SAVLIB
of all three libraries to the same save file.
B. Create three save files. Perform a separate SAVLIB
of each library to individual save files.
C. Create three save files. Perform a single SAVLIB
expanding the library and save file parameters to
accommodate the three libraries and save file names.
D. Create one save file. Perform a single SAVOBJ command
specifying *ALL for the object and expanding the library
parameter to accommodate the three library names.
Users are complaining that they cannot release spooled
files that their job has created. What must be done
to correct the problem?
A. The printer device must be active.
B. A writer must be attached to the output queue.
C. The output queue must be in a RLS status before
spooled files can be released.
D. The authority to check (AUTCHK) parameter of the
output queue must be changed to *DTAAUT.
What is the meaning of the "A" or "B"
source for an i5/OS IPL?
A. Selecting the "A" source will
IPL the system to DST.
B. This refers to which copy of microcode the system
loads at IPL.
C. Selecting the "A" source causes the system
to come up in debug mode.
D. Selecting the "B" source will cause the
system to not load any pending microcode PTFs.
An operator wants all system operator messages greater
than severity 70 sent immediately to the operator's
screen. Which of the following parameters of the CHGMSGQ
MSGQ(QSYSOPR) command will accomplish this?
A. DLVRY(*BREAK) SEV(70)
B. DLVRY(*IMMED) SEV(70)
C. DLVRY(*NOTIFY) SEV(70)
D. DLVRY(*INTERRUPT) SEV(70)
A network switch has been replaced which required
the Ethernet line to be varied off. The switch is
back in place and the line has been varied back on
but users cannot connect to the system. Which of the
following is a likely cause for the problem?
A. The TCP/IP Interface must be restarted.
B. The Ethernet line must be varied on with RESET(*YES).
C. The TCP/IP Route must be re-established after the
D. The hardware MAC address of the new switch must
be added to the i5/OS Host Table.
Which of the following media is used to save a library
to an external DVD drive?
Which of the following is used to view objects in
any file system of the IFS?