Designing and Implementing HP LeftHand SAN Solutions
Answers, Braindumps (HP0-J36)
These are Guaranteed question for this exam. I only
used www.exams.ws guide and i was succedded.
What are valid management areas for administrative groups?
A. system settings, passwords
B. network, boot, upgrade
C. management groups, RAID, drive hotswap . storage
node administration, monitor, disk report
D. change password
Where is RAID configured in HP LeftHand SAN solutions?
A. at the volume level
B. at the storage node level
C. at the cluster level
D. at the management group level
Which types of host bus adapters (HBA) can be used for
the iSCSI protocol? (Select two.)
A. SWiSCSI initiator without a NIC (network interface
B. iSCSI HBA with TCP offload engine (TOE)
C. Fibre Channel HBA
D. NIC with SWiSCSI initiator
E. iSCSI HBA with TCP TOE SW iSCSI initiator
Which statements about iSCSI are correct? (Select two.)
A. iSCSI does not offer any security features.
B. iSCSI installation is less complex than Fibre Channel
C. iSCSI is only supported by Microsoft Windows operating
D. iSCSI is available for the most common OS platforms.
E. iSCSI is a parallel data protocol.
You are creating a server without CHAP authentication.
Where on the server do you find the Initiator Node Name?
A. from the TCP/IP properties
B. in the application properties
C. from theiSCSI initiator
D. in the server properties
Which statements about HP LeftHand SAN replication levels
are correct? (Select three.)
A. Copies are located on different clusters.
B. Redundant copies of blocks reside on different storage
C. Performance improves as the number of copies increases.
D. Up to four copies can be created.
E. The replication level is defined per storage node.
F. The replication level cannot exceed the number of
storage nodes in the cluster.
What are typical examples of snapshot utilization? (Select
A. replacement for traditional backups
B. protection against disk failures
C. protection against multiple hardware failures
D. protection against manual data deletion
E. file level restore without tape or backup software
F. source volumes for backup creation
Which performance statistics does Performance Monitor
collect? (Select three.)
A. storage module I/O
B. iSCSI HBA CPU load
C. storage module CPU
D. centralized management console usage
E. iSCSI I/O
F. individual disk performance
Which data management features are provided by the SAN/iQ
software? (Select three.)
A. server virtualization
B. SmartClone volumes
C. automated backup of application data
D. remote copy of data
E. automated failover to a remote site
F. automated failover to another node in the cluster