Implementing HP ProLiant Servers
Answers, Braindumps (HP0-645)
I cleared exam
yesterday and passes it. It was really hard. I did
not find any dumps for this exam. some of the questions
from exams are there.
I thank to all the dumpers who all sent their braindumps
to this site and hel
What is the most likely problem when you receive only
audible codes (beeps) during POST?
A. The monitor signal is not connected.
B. The system sees intermittent memory parity errors.
C. No memory modules are present.
D. The monitor is in power saver mode.
You need to replace a PCI controller in a HP ProLiant
server while the server is running. PCI Hot-Plug technology
enables you to shut down power to the PCI_______________.
A. riser board
Because of the power and heat generated by systems
in a racked environment, what should do to ensure
that excessive thermal conditions do not impede production
activities? Select two.
A. Align rows of racked systems in the same direction
1 meter apart.
B. Use blanking panels for unused space within the
C. Enclose the front of the rack with a ventilated
D. Enclose the rear of the rack with a solid door.
E. Remove the side panels on the rack enclosure.
Answer: B, C.
Which System Agent will shut down an HP Industry Standard
Server when a thermal event occurs?
A. Storage agent
B. Server agent
C. Power agent
D. Foundation agent
You are troubleshooting a system with PCI slots, but
you do not know what voltage the PCI slots support.
Which PCI card can operate in a 5V or 3.3V PCI slot?
A. A standard 32-bit 33 MHz PCI card
B. A universal PCI card
C. A dual-capability 32/64-bit PCI card
D. An advanced 33/66MHz PCI card
A company has several similarly configured application
servers deployed throughout its facilities. All but
one server are meeting performance expectations. To
determine the performance problem, the IT staff would
like to collect historical performance information
over the past several weeks from these servers and
compare the data against the under performing server.
This information must include platform-specific data
from all major subsystems and their components. Which
tool would be best suited for this task?
A. Performance Management Pack (PMP)
B. Workload Management Pack (WMP)
C. Windows System Monitor
D. HP OpenView
In a properly configured HP rack enclosure, airflow
is designed to flow_______________.
A. In the top and out the bottom.
B. In the front and out the top within the enclosure.
C. In the front and out the back within the enclosure.
D. In the rear and out the top within the enclosure.
After replacing several drives, the same hard drives
repeatedly go into prefailure state. What should you
A. Run the Array Configuration Utility and check the
health of the storage.
B. Run the Array Configuration Utility and analyze
the report before deciding on a further course of
C. Suggest replacing the drive cage and array controller.
D. Upgrade the server ROMpaq and monitor for reoccurrence
of the problem.