Supporting SAN Infrastructure & Solutions
Exam Questions, Answers,
Here r some dumps.Original
r also available on www.exams.ws
What should be the maximum number of active storage
controller ports per inter-switch link in a high throughput
Which factor can reduce the performance between devices
in a Fibre Channel SAN?
A. hop count
B. switch latency
C. inter-switch link latency
D. inter-switch link congestion
Which ports should you use on a B-series switch to
establish two Wavelength Division Multiplexing links
to a remote site?
A. ports which belong to the same "Quad"
B. ports which belong to different "Quads"
C. ports on different switches
D. only 2 Gbps ports
What do you recommend if a performance bottleneck
is discovered on a link between a 1 Gbps and a 2 Gbps
A. Implement trunking on this link.
B. Implement port channeling on this link.
C. Use multi-mode cable instead of single mode.
D. Replace the 1 Gbps switch with a 2 Gbps switch.
A complex SAN designed for applications with small
IOs is used primarily by applications with large IOs.
What is the impact to the SAN?
A. The supported hop count is reduced.
B. There may be congestion on inter-switch links.
C. None. SAN design is not dependent on application
D. The buffer-to-buffer credit on the storage system
must be recalculated.
What allows you to check if the configuration of a
new switch is compatible with an existing fabric configuration
in a B-series fabric?
A. Network View
B. Fabric Manager
C. High Availabiity Fabric Manager
D. OpenView SAN Manager
What is the most effective way to integrate 2 Gbps
switches in existing 1 Gbps switch fabrics with many-to-many
A. Use 2 Gbps as core and 1 Gbps as edge switches.
B. Use 1 Gbps as core and 2 Gbps as edge switches.
C. Create separate zones for the 1 Gbps and 2 Gbps
D. Use trunking to link every two 1 Gbps ports to
a 2 Gbps connection.
Which zoning type is supported if B-series switches
are connected to third-party switch products?
A. switch/port level
B. AL_PA level
D. WWN level