Implementing Advanced Cisco Unified Wireless Security
Submitting dumps with some changes. The original
is also available in www.4exam.com
QUESTION NO: 1
What is the purpose of looking for anomalous behavior
on a WLAN infrastructure?
A. Identifying new attack tools
B. Auditing employee's bandwidth usage
C. Identifying attacks using signature matching
D. Improving performance by load balancing
QUESTION NO: 2
As of controller release v5.2, which two statements
about wired guest access support are true? (Choose two.)
A. It is not supported on the Cisco 2100 Series Controllers.
B. No more than three wired guest access LANs can be
configured on a controller.
C. Layer 3 web authentication and passthrough are not
D. Wired guest access cannot be configured in a dual-controller
configuration that uses an anchor controller and a foreign
E. The wired guest access ports must be in the same
Layer 2 network as the foreign controller.
QUESTION NO: 3
The wireless client can roam faster on the Cisco Unified
Wireless Network infrastructure when which condition
A. EAP-FAST is used for client authentication on the
B. Cisco Centralized Key Management is used for Fast
C. QoS is being used on the WLAN to control which client
packets get through the network faster.
D. RRM protocol is used between multiple APs that the
client associates to while roaming.
QUESTION NO: 4
Which option best describes an evil twin attack?
A. A rouge access point broadcasting a trusted SSID
B. A rogue access point broadcasting any SSID
C. A rouge ad-hoc with the SSID "Free WiFi"
D. A rouge access point spreading malware upon client
QUESTION NO: 5
When using Cisco Secure Services Client to configure
a wireless LAN connection that uses EAPFAST, which three
options are available as the inner authentication method?
F. Pre-shared key
QUESTION NO: 6
Which two 802.11 frame types can be used in a virtual
carrier (big NAV) attack? (Choose two.)
QUESTION NO: 7
When adding the foreign controller as a mobility group
member in the guest anchor controller, which statement
A. The mobility group name on the guest anchor controller
must match the mobility group name on the foreign controller.
B. The mobility group member IP address and MAC address
belong to the management interface of the foreign controller.
C. To successfully add the foreign controller as a mobility
group member in the guest anchor controller, all the
parameters defined in the WLAN Security, QoS, and Advanced
tabs must be configured identically in both the anchor
and foreign controller.
D. In the guest anchor controller GUI, WLANs > Mobility
Anchors page, use the Switch IP Address (Anchor) drop-down
menu to select the IP address corresponding to the management
interface of the anchor controller.